fault condition
英 [fɔːlt kənˈdɪʃn]
美 [fɔːlt kənˈdɪʃn]
网络 故障条件; 保护电路动作后; 故障
双语例句
- But under fault condition, the system current is greater than the current of equivalent AC current source and the limiting resistance take effect immediately.
故障后，系统电流值远大于等效交流电流源值，限流电阻立刻自动投入限流。 - Fault Condition Recognition with Kernel Principal Component Analysis Based on Particle Swarm Optimization
基于粒子群优化的核主元分析的故障状态识别 - Simulation Analysis of Vibration Characteristic of Steam Turbine Rotor under Fault Condition
汽轮机转子故障状态下的振动仿真分析 - Frequency Rehabilitation Programme in Series Fault Condition of North-east Network
东北电网严重事故状态下的频率恢复方案研究 - If there are high voltage cables running anywhere near the data cables, the potential for a fault condition exists as a result of insulation failures or inadvertent contact by an installer.
如果数据电缆附近有高压电缆经过，在诸如绝缘失效、外接触设备，则会存在故障电势。 - Configuration software with the image display Coal Mine Belt transport, through CAN bus, the Underground Monitoring collected conveyor operation or transmission to the ground fault condition;
用组态软件形象显示煤矿井下皮带运输，通过CAN总线，将井下监控分站采集到的皮带机运行或故障状态传输到地面； - The vibration characteristic of the motor in fault condition was monitored by creating broken-bar faults artificially.
再通过人为的制造转子断条故障，监测电机在故障情况下的转速转矩变化及振动特性。 - Moreover, this control system also has such functions as the emergency shutdown under fault condition, sludge collection and video monitor for operation status.
同时，该系统还具有事故工况下急停、泥渣收集和运行状态视频监视等功能。 - Two-dimension spectrum entropy is extracted as the character index of machine state by analyzing the frequency spectrum of vibration signals. With the application of bearing's condition measurement, normal and fault condition is distinguished directly.
分析了机械振动信号的频谱特征，将二维信息谱熵作为机械状态的特征指标，应用到轴承的状态监测，直观地辨别出正常和故障两种状态。 - The system can demonstrate operating modes under normal or fault condition and the process of fault isolation of the distribution network.
系统能演示配电网的正常运行方式和故障运行方式及故障隔离过程。 - Applying lots of primal features to identify fault condition leads to reduce classification correctness.
在机械故障诊断中，基于原始大特征量的故障状态识别会导致识别精度的下降。 - The Performance Characteristic Analysis of Transformer Differential Protection in a Complex Fault Condition
复杂故障情况下的变压器差动保护动作特性分析 - The experimental results show that the combination of main-eigenvector and support vector machine distinguish the normal and fault condition finely, and it also has good recognition ability to unknown fault samples.
试验结果表明，奇异值分解后的主特征矢量与支持向量机相结合可以很好的分辨出轴承的正常和故障状态，并且对未知故障有良好的识别能力。 - The secondary system is equipped with perfect protection and control function, so the capacitor will be automatically out of service at abnormal or at fault condition and resume to work automatically after primary system is back to normal.
二次系统设置完善的保护与控制功能，实现在异常或故障状态下电容器的自动退出运行，并在一次系统恢复正常后自动投入； - Based on fractal theory and phase space reconstruction arithmetic, the generator vibration correlation dimension is analyzed when the generator is in normal condition, rotor excitation winding short circuit and stator winding fault condition.
运用分形理论的相空间重构算法，分析了发电机在正常运行、转子励磁绕组短路和定子绕组故障3种状态时定转子振动信号的关联维数。 - The test result shows that after the extraction of PCA, the SVDD classifier distinguished the normal and fault condition finely, and it also has good recognized ability to unknown fault samples.
试验结果表明，PCA对正常和故障样本有较大的区分度，SVDD分类器能很好的分辨出轴承正常和故障状态，并且对未知故障有良好的识别能力。 - Gaining the simulation data of traveling wave signal under every fault condition by ATP.
利用ATP得到了线路各种故障情况的行波信号的仿真数据； - The research on over-voltage protection of TCSC is mostly about how to protect TCSC and MOV under fault condition as well as how to reduce the energy consumption level. Consequently, the protection can both meet the requirement of economy and benefit the transient stability of system.
TCSC的过电压保护主要研究故障情况下保护TCSC和MOV的方式以及如何降低MOV能耗水平，以满足经济性要求，同时又有利于系统暂态稳定。 - By means of computered modeling and simulating, the variation of the discrepancy of motor voltage and valve angle are analyzed when system working at proper or fault condition.
利用计算机建模与仿真的方法，对电动节流阀控制系统正常和异常时电机电压和阀门转角的波动进行了分析。 - Before applying this fault diagnosis method, it is needed to get the sensor output data under fault condition to establish a fault pattern sequences set.
应用此方法进行故障诊断之前，需要获取传感器故障状态下的输出数据建立一个故障模式序列集。 - The main research achievements are as follows: 1. Comprehensively understand and grasp the technical process and fault condition of catalytic cracking device, collect and arrange the fault knowledge and rules.
本论文的主要研究成果包括以下几个方面：1、全面了解和掌握催化裂化装置的工艺流程及其故障情况，收集和整理大量的故障知识和规则。 - Fourthly, it simulated the possible generated fault condition in testing period and constituted relative solutions.
第四，对试验过程中可能出现的故障情况进行仿真，并制定了相关应对措施。 - The hardware in the loop ( HIL) test of electric traction system and auxiliary supply system can provide a relative real external environment, especially in fault condition which may not realized in Laboratory.
摘要：硬件在回路仿真可以在电力牵引以及辅助变流器驱动控制器开发过程中，为实际系统中关键软硬件提供一个接近真实的控制环境，特别是极限，故障条件下的测试。 - Experiments show the proposed methods can effectively and accurately identify roller bearing fault condition, validated the proposed based on non stationary time series analysis of rolling bearing fault feature extraction method is effective.
实验表明，本文所提方法可以有效、准确地识别滚动轴承的故障状况，验证了论文提出的基于非平稳时序分析的滚动轴承故障特征提取方法的有效性。 - This method need to collect the data both under the normal condition and fault condition.
这一方法要求收集正常操作条件下，以及在各种故障状态下的历史数据。 - Also analyzed in detail the operation of the Distributed Power Generation System in the typical fault condition.
还对典型故障状态下分布式发电系统并网运行情况作了详细分析。 - As the characteristic gas of oil-filled power transformer, acetylene is the symbol of the fault condition.
同时，作为大型电力变压器油中的故障特征气体之一，是变压器内部故障判断和故障程度的重要标志。 - But the calculation of the critical value for branch resistance in fault condition exists unsettled.
然而，支路电阻在故障电流作用下，其安全阈值的计算一直是困扰研究者多年的问题。 - Then the fault condition in EMP interference can be analyzed by backup critical system registers and memory status.
通过实时备份系统中关键寄存器和存储器的状态来分析系统受电磁脉冲干扰而产生的故障特性。 - By analyzing the parameters changing under normal operation condition and rotor winding inter-turn short circuit fault condition, the rotor vibration characteristics and the stator winding parallel branches circulating current characteristics are investigated.
通过分析汽轮发电机转子正常运行及匝间短路故障运行时各参数的变化，推导出转子匝间短路造成的转子径向振动特征和定子绕组并联支路环流特征。